A bathroom remodel is a great way to add more value and comfort to your home. After the bathroom remodel is done you have the perfect bathroom that is right for you. The problem you may have however is that it doesn’t quite work the way you wanted. One reason why a bathroom remodel can turn into a disaster is if you have bad water pressure or slow drains. Water pressure can be addressed sometimes easily during the project but for slow drains you’ll likely need a rooter in Downriver Michigan to clear your sewer and drain lines. We’ll go through a few things you should look for to avoid this problem.
A Bathroom Remodel May Be Too Much for Your Plumbing in Downriver Michigan
Getting a bathroom remodel in Downriver Michigan is a great project because it doesn’t affect the overall function of your home in most cases. The bathroom remodel project can be done while you still occupy the home. But when there is a problem with the home’s plumbing it can make that stay rather dreadful. And in some cases, the entire drain system may need to be replaced in some cases. Either way, learning what it means to have problems with a slow drain and what you can do about it is covered below.
The biggest reason why homes have slow drains is the main drain system is not capable of allowing the water and sewage to drain as fast as it can be introduced in the home. For instance, when you draw water into your home’s bathtub it should run out the drain just as fast as it comes in. For most tubs the rate of water should be 2.5 gallons per minute. So your drain should also drain at 2.5 gallons per minute or even faster. If you have low water pressure in your bathroom that introductory rate may only be 1 gallon per minute. So even though you have less water being introduced you drain should still have capacity to drain at least 2.5 gallons per minute.
Why You May Have a Problem
So, if you do have low water pressure the plumber may introduce components to ensure you get better water pressure. With this increased water pressure and flow it can put more stress on the drain to clear the water. Without a proper balance, the tub will overfill and spill onto the floor of the home which can lead to damage. And while it may seem like the problem is caused by more water pressure, it’s actually caused by a sewer line problem.
Over time, the sewer line in your home can become partially blocked by grease, roots, and a variety of other materials. While these materials may not block the line completely, they can partially block the sewer line only allowing a smaller amount of water and waste to come through. While this may be enough area before your bathroom remodel when you add tubs, showers, and fixtures that may have higher flow rates it can quickly cause the drains to run slower and sometimes become clogged. The best way to deal with this issue if to have the sewer line cleared or replaced.
Look For Signs of Slow Drains Before You Remodel
The good news is that this problem can be repaired quite easily and quickly as long as you use a good plumber. The best to determine if your drains are running slow is to fill your bathtub with water and see how long it takes to drain and the drain rate. If the drain runs fast to start and then slows you may have a problem.
Call a Professional Plumber to Clear Your Sewer Line
If you have problems with your sewer line you don’t need to wait until you want to get a bathroom remodel done on your home. When your drains are running slow or you have other drainage problems be sure to call a plumber to clear the sewer line of your home. It’s always best to only use a licensed, professional plumbing service for best results. Be sure to call Downriver Plumbers for any type of rooter or sewer line repair for your home. They are fully licensed and insured and offer emergency plumbing service as well. Call them at (734) 548-9925 for plumbing service for your home.
